CE/DE Replacement and High Frequency T/R Upgrade

Thay thế cực thu, cực phóng và nâng cấp máy biến áp cao tần

Application
ỨNG DỤNG

Cooler ESP of a cement plant in Vietnam with its capacity 4,100 tons/day.
Lọc bụi Cooler của một nhà máy xi măng ở Việt Nam với công suất 4,100 tấn/ giờ.

Problem
VẤN ĐỀ

  1. Dust build-up was observed on inlet Gas Distribution (GD) Screen, Collecting Electrode (CE) and Discharge Electrode (DE), which led to high sparking during operation.
    Bụi đóng bám ở tấm chia khí đầu vào, cực lắng, cực phóng, dẫn tới phóng điện nhiều khi vận hành.
  1. Discharge Electrodes were damaged and broken, which caused short-circuit.
    Cực phóng bị hư hỏng, gây ra hiện tượng ngắn mạch.
  1. Customer expected to reduce their emission from 60mg/Nm3 to less than 20mg/Nm3.
    Khách hàng mong muốn giảm nồng độ thải từ 60mg/Nm3 xuống  dưới 20mg/Nm3.

Solution
CÁCH GIẢI QUYẾT

Tai & Chyun recommended replacing CE and DE for 2 fields as well as upgrading  Conventional T/R into High Frequency T/R for the 1st and 2nd field. In addition, maintenance and supervision were also performed during the outage. The installation was completed within 25 days as below work scopes:

Công ty Tai&Chyun đề xuất thay thế cực phóng và cực lắng cho 2 trường, đồng thời naanng cấp máy biến áp truyền thống thành máy biến áp cao tần cho trường số 1 và số 3. Ngoài ra, chuyên gia của Tai&Chyun còn thực hiện việc bảo trì và giám sát lắp đặt trong quá trình sửa chữa, thay thế. QUá trình lắp đặt diễn ra trong vòng 25 ngày với những nội dung dưới đây:

  1. Replacing Collecting Electrodes and Discharge Electrodes for the 2nd and 3rd field.
    Thay thế cực lắng và cực phóng cho trường số 2 và số 3
Bent old CE
Bent old CE
Hardened dust built-up on old RDE
Hardened dust built-up on old RDE
Stabilizing bar and traverse installation
Stabilizing bar and traverse installation
New CE installation
New CE installation
New RDE installation
New RDE installation
DE clip installation
DE clip installation

2.Installing new GD screen at ESP inlet.
Lắp đặt mới tấm chia khí đầu vào

Dust-coated and blocked inlet GD screen
Dust-coated and blocked inlet GD screen
New GD screen

3.Upgrading into new High Frequency T/R for the 1st and 2nd field.
    Nâng cấp máy biến áp cao tần cho trường 1 và trường 2

Old T/R dismantlement
Old T/R dismantlement
Old Conventional T/R
Support for new High Frequency T/R
Support for new High Frequency T/R
New High Frequency T/R
New High Frequency T/R

Benefit
LỢI ÍCH

New RDE and maintenance recovered ESP performance. With High Frequency T/R upgrade, ESP collection efficiency increased and reached the emission reduction target of less than 20mg/Nm3. Meanwhile, the gas volume also increased with comparison to that before the overhaul and thus exceeded customer expectation.

Thanh cực phóng mới dạng xương cá RDE và việc bảo trì đã giúp phục hồi lại hiệu suất của lọc bụi. Với việc nâng cấp máy biến áp cao tần, hiệu quả thu bụi của lọc bụi đã tăng và đạt tới mức dưới 20mg/Nm3. Trong khi đó, lượng khí bụi lại tăng lên so với trước khi lắp đặt, do đó khách hàng vô cùng hài lòng với kết quả.

March 2018 May 2019
Gas volume m3/h 324,000 414,000
Production capacity T/D 4000 4339
Emission mg/Nm3 60 15
Emission result from CCR showed 15mg/Nm3
Emission result from CCR showed 15mg/Nm3

Result from electrical readings also showed significant improvement in power output, which is increased secondary voltage (kV) and secondary current (mA). As shown in the below tables, ESP could only operate at low power output due to heavy sparking before the overhaul. After the upgrade, ESP could produce more power output indicating ESP dust collection efficiency also increased.

Kết quả từ thông số điện dưới đây chỉ ra sự cải thiện đáng kể trong nguồn điện đầu ra, nghĩa là dòng và áp đều tăng lên. Bảng dưới thể hiện lọc bụi chỉ có thể vận hành ở nguồn điện đầu ra thấp do phóng điện nghiêm trọng trước khi sửa chữa. Sau nâng cấp, lọc bụi đã có thể tạo ra nhiều điện đầu ra hơn, ám chỉ hiệu suất thu bụi của lọc bụi đã tăng lên.

Before Retrofit (Oct 2018)

Field 1 Field 2 Field 3
kVmean 11 18 44
mA 30-40 25-40 50-70

After Retrofit (May 2019)

Field 1 Field 2 Field 3
kVmean 31 32 24
mA 60-80 140-170 130-170