ESP Electrical Upgrade
Nâng cấp hệ thống điện cho lọc bụi tĩnh điện
Application
Nơi áp dụng
ESP installed in the power unit of a steel plant situated in Taiwan
Lọc bụi tĩnh điện (ESP) của nhà máy thép ở Đài Loan
Problem
Vấn đề
The current transformer rectifier set was old being in operation for many years. The main problems are listed below:
Bộ chỉnh lưu của máy biến áp quá cũ do hoạt động nhiều năm. Những lỗi xuất hiện chủ yếu như sau:
- Occurrence of signal interference problems leading to the disorder of the conventional controller operations and also high opacity rate.
Tín hiệu truyền kém, dẫn đến bộ điều khiển không điều khiển chính xác được theo thông số vận hành và độ mờ phát thải cao
- Frequent occurrence of keypad/display malfunction hindered the access of operation for parameters adjustment.
Bàn phím và màn hình thường xuyên bị lỗi lầm cho việc thay đổi và truy cập các thông số vận hành bị khó khăn
Máy biến áp cũ
Máy biến áp cũ
Solution
Giải pháp
Tai & Chyun engineers went on site and collected the related information, for example type of coal burnt, emission rate, current consumed against the operating data (kV/mA/Spark) etc., and came up with the proposal of upgrading existing conventional T/R sets to High Frequency T/R set that will guarantee to improve the emitting characteristics and power supply efficiency as well. With this proposal, full planning and management of material, supervision, test and commissioning were smoothly performed and achieved the outstanding results.
Kỹ sư Tai&Chyun đã đến khảo sát và đo đạc số liệu như loại than đốt, nồng độ phát thải, năng lượng tiêu thụ tương ứng với thông số vận hành…, sau đó đưa ra kế hoạch nâng cấp biến áp chỉnh lưu thường sang biến áp chỉnh lưu cao tần, loại biến áp cao tần này sẽ nâng cao khả năng hoạt động và sử dụng năng lượng hiệu quả. Trong đó T&C cung cấp đủ vật tư thiết bị, hướng dẫn lắp đặt, và chạy thử. Thiết bị vận hành trơn tru và được đánh giá xuất sắc.
Lắp đặt biến áp chỉnh lưu cao tần mới
Lắp đặt biến áp chỉnh lưu cao tần mới
Benefits
Lợi ích
After electrical field upgrade, the operating values were recorded as follows.
Sau khi nâng cấp, thông số vận hành được ghi nhận như sau
The ESP was functioning efficiently with high collection efficiency and low emission rate. The contract requirement for the emission rate was less than 10 mg/Nm3, but it is seen that the actual emission rate recorded were 2.7 mg/Nm3 and 1.3 mg/Nm3 for coal combustion and coal+10KN BFG combustion respectively. Also, around 41% of power was saved per year.
ESP hoạt động hiệu quả với khả năng thu bụi cao và nồng độ phát thải thấp. Nông độ phát thải được đề cập trong hợp đồng là dưới 10 mg/Nm3 tuy nhiên, nồng độ phát thải thực tế sau khi nâng cấp còn tốt hơn nhiều, cụ thể là 2.7 mg/Nm3 và 1.3 mg/Nm3 cho than cháy và than +10KN BFG
Type of Fuel Loại nhiên liệu |
Coal only Than thường |
Coal + 10 KN BFG Than +10 KN BFG |
|
Operating Values Thông số vận hành |
Before Trước |
37.1 kV / 298.3 mA | 35.2 kV / 299 mA |
After Sau |
35.6 kV / 298.4 mA | 36.7 kV / 298.5 mA | |
Boiler Loading (Ton / Hr) Công suất lò hơi |
Before Trước |
195.2 | 197.2 |
After Sau |
188.1 | 191.8 | |
Emission (at the Outlet) Phát thải |
Before Trước |
5 mg/Nm3 | N/A |
After Sau |
2.7 mg/Nm3 | 1.3 mg/Nm3 | |
Collection Efficiency Khả năng thu bụi |
99.95 % | 99.98 % | |
Power Saved (per year) Tiết kiệm năng lượng |
47.03 % | 46.52 % |